![]() ![]() Delay before running command in Terminal: Additional time before the command is executed.Delay before opening Terminal: The amount of seconds between pressing ⌘R and issuing the commands to open Terminal to run the command.SMB Server mkdir /tmp/mnt & mount_smbfs /tmp/mnt & hdiutil mount /tmp/mnt/mds/MDSDiskImage.dmg & /Volumes/MacDeployStickResources/run Web Server hdiutil mount & /Volumes/MacDeployStickResources/run Depending on where the resources are located, the command will be different. It should be adjusted to match the name of the external volume (replace “mds” with the name of the volume that contains the MDS resources). Command: Listed is the command that will run in Terminal in the recovery partition. ![]() MDS will prompt to update the Automaton if it has older firmware than what is provided in the current MDS version. Version: View the current Automaton firmware version.These values can be adjusted using the Configure Mac Automaton sheet. It will then wait for a defined startup delay before issuing the commands for opening Terminal and running the specified command. The Automaton will press ⌘R a few seconds after it has been plugged in. SettingsĬlick “Configure Mac Automaton” to change options. Note: the MDS Automaton must be connected when the configuration sheet is shown as it only listens for a connection over a few seconds on initial power. Once the Configure sheet is displayed, plug in the Automaton using the provided USB cable. Match the also burnt in CRC for that MAC address, resulting in an error like Base MAC address from BLK0 of EFUSE CRC error.To configure the MDS Automaton, launch MDS and click the “Configure Mac Automaton” button. Ignore_efuse_mac_crc ( Optional, boolean): Can be set to true for devices on which the burnt in MAC address does not Sdkconfig_options ( Optional, mapping): Custom sdkconfig options to set in the ESP-IDF project.Īdvanced ( Optional, mapping): Advanced options for highly specific tweaks. ![]() This can be used to use a custom or patched version of the framework. Source ( Optional, string): The PlatformIO package or repository to use for the framework. # Example configuration entry esp32 : board : esp32-c3-devkitm-1 framework : type : esp-idf version : recommended # Custom sdkconfig options sdkconfig_options : CONFIG_COMPILER_OPTIMIZATION_SIZE : y # Advanced tweaking options advanced : ignore_efuse_mac_crc : false Configuration variables: ¶ĮSP32 ESP-IDF releases. Of the ESP32 like ESP32S2, ESP32S3, ESP32C3 and single-core ESP32 chips. This is an alternative base framework for ESP32 chips, and recommended for variants Platform_version ( Optional, string): The version of the platformio/espressif32 package to use. ![]() Source ( Optional, string): The PlatformIO package or repository to use for framework. Recommended: Use the recommended framework version. Latest: Use the latest release from, even if it hasn’t been recommended yet. Additional values are:ĭev: Use the latest commit from, note this may break at any time Version ( Optional, string): The base framework version number to use, fromĮSP32 arduino releases. # Example configuration entry esp32 : board : nodemcu-32s framework : type : arduino version : 2.0.0 Configuration variables: ¶ ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |